Industrial-1010

Product Description

Industrial 1010 Fog Out a specialty water-based acrylic semi-gloss dry fall designed for commercial ceilings. Overspray dries to powder after falling approximately 12 feet. Fog Out properties will depend on an ambient temperature and humidity.

Interior • Acrylic Water – Based Semi-Gloss Finish

  PDS     MSDS 

SKU: Legacy-1010 Category:
Certification
SCAQMD - complies with Rule 1113, Architectural Coating
LEED - complies with GS-11 / EQ 4.2.

MPI Approved MPI Green
Recommended Uses
Industrial and commercial ceilings where good hide and adhesion are required.
Bases
Special order, white and pastels only.
Packaging
Five gallon containers
Finish
Semi-Gloss, sheen @ 60° = 36 - 40 %
Surface Preparation
WARNING! Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead. Exposure to lead dust or fumes may cause brain damage or other adverse health effects, especially in children or pregnant women. Controlling exposure to lead or other hazardous substances requires the use of proper protective equipment, such as a properly fitted respirator (NIOSH approved) and proper containment and cleanup. For more information, call the National Lead Information Center at 1-800-424-LEAD (in US) or contact your local health authority. To ensure proper adhesion, the surface to be painted must be free of dirt, dust, oil, grease, wax, rust, and any other surface contaminants. Clean surface using an appropriate cleaner. Rinse thoroughly and allow to dry. Sand or scrape surface to remove any loose paint and to smooth old surfaces. Dull glossy surfaces by using 150 grit sandpaper.
Fill cracks and holes with spackling paste to smooth uneven areas. When dry, sand and remove sanding dust.

Masonry, Concrete Block: All new surfaces must be cured according to the supplier’s recommendations—usually at least 30 days – and have a pH between 7 and 10. Remove all form release and curing agents, efflorescence, salts, laitance, and other foreign matter. Patch cracks and holes with an appropriate filler. Rough surfaces may be filled to provide a smooth surface.

Wood, Pre-Primed Fiberboard, Hardboard, Plywood: Sand any exposed wood to a fresh smooth surface. Patch all holes and imperfections with a wood filler or putty and sand smooth. Remove all sanding dust.

Aluminum and Galvanized Metal: Wash with appropriate cleaner to remove any oil, grease, or other surface contamination using a water-based cleaner-degreaser. Remove all corrosion with sandpaper, steel wool, or other abrading method.
Primer
•Concrete : 1040 MASONRY PRE-COAT
•Wood • Ferrous Metal • Non-Ferrous Metal: 1420 ONE PRIME
Application
Temperature (air, surface, and material) 12.8°C (55°F) and relative humidity below 80% Spray only. Airless Spray: Pressure - 2000 psi, Tip - .015”-.021”, Reduction - Not recommended.
Drying Time
Touch: 15-20 minutes
Coverage
300-350 square feet per gallon, depending on surface
Mil Thickness
Wet - 3.5 • Dry - 1.5
Thinning
DO NOT THIN
Composition
Titanium Dioxide 16.5%, Extenders 11.5%
TOTAL PIGMENT 28%
Acrylic Resin 20.2%, Additives 9.1%, Water 42.7%
TOTAL VEHICLE 72%
Weights & Measurements +/-3.0%
Solids by Volume: 41.5%
Solids by Weight: 54.8%
VOC: 34 g/l
Weight Per Gal: 10.9 lbs.
Viscosity: 88 - 92 KU