Primer-1110

Product Description

Legacy 1110 Seal It a premium plus pigmented high-solids PVA sealer for new drywall and plaster. This product has very good enamel hold-out and sealing properties.

Interior / Exterior • Acrylic Heavy Bodied Masonry Pre-Coat

  PDS     MSDS 

SKU: legacy-1110 Category:
Certification
SCAQMD - complies with Rule 1113, Architectural Coating
LEED - complies with GS-11 / EQ 4.2.

MPI Approved #50 MPI Green
Recommended Uses
New interior drywall and plaster.
Bases
White
Packaging
One and five gallon containers
Finish
Mat @ 85° = 2.5 - 3.5 %
Surface Preparation
WARNING! Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead. Exposure to lead dust or fumes may cause brain damage or other adverse health effects, especially in children or pregnant women. Controlling exposure to lead or other hazardous substances requires the use of proper protective equipment, such as a properly fitted respirator (NIOSH approved) and proper containment and cleanup. For more information, call the National Lead Information Center at 1-800-424-LEAD (in US) or contact your local health authority. To ensure proper adhesion, the surface to be painted must be free of dirt, dust, oil, grease, wax, rust, and any other surface contaminants. Clean surface using an appropriate cleaner. Rinse thoroughly and allow to dry. Sand or scrape surface to remove any loose paint and to smooth old surfaces. Dull glossy surfaces by using 150 grit sandpaper. Fill cracks and holes with spackling paste to smooth uneven areas. When dry, sand and remove sanding dust.

Drywall: Wipe with a damp cloth to remove dust. Allow to dry. Fill cracks & holes with spackling compound and sand smooth. Joint compound must be cured and sanded smooth. Remove all sanding dust.

Plaster: All new surfaces must be hard and cured according to the supplier’s recommendations—usually at least 30 days. Treat textured, soft, porous, or powdery plaster with a solution of 1 pint household vinegar to 1 gallon of water. Repeat until the surface is hard, rinse with water and allow to dry.
Primer
Application
Temperature: (air, surface, and material) 12.8°C (55°F) and relative humidity below 80%. Airless Spray: Pressure - 2000 psi, Tip - .015”-.021”, Reduction - Not necessary. Brush: Brush - Nylon / Polyester, Reduction - Not recommended. Roller: Cover - 6 mm - 19 mm (1/4” - 3/4”) synthetic, Reduction - Not recommended.
Drying Time
Touch: 1 hour
Recoat: 4 hours
Coverage
300-375 square feet per gallon, depending on surface
Mil Thickness
Wet - 18.0 - 22.4
Dry - 8.4-10.4
Thinning
Use at package consistency. If thinning is required, use water sparingly.
Composition
Titanium Dioxide 14.4%, Extenders 13.9%
TOTAL PIGMENT 28.3%
Vinyl Acrylic 20.0%, Additives 5.8%, Water 45.9%
TOTAL VEHICLE 71.7%

Weights & Measurements +/-3.0%
Solids by Volume: 36.6%
Solids by Weight: 50.6%
VOC: 97 g/l
Weight Per Gal: 10.73 lbs.
Viscosity: 92 KU