LEED - complies with LEED 2009 and LEEDv4 - Low Emitting Materials
CDPH Section 01350 - tested and passed
MPI - #119
Drywall: Wipe with a damp cloth to remove dust. Allow to dry. Fill cracks & holes with spackling compound and sand smooth. Joint compound must be cured and sanded smooth. Remove all sanding dust.
Masonry, Concrete Block: All new surfaces must be cured according to the supplier’s recommendations—usually at least 30 days – and have a pH between 7 and 10. Remove all form release and curing agents, efflorescence, salts, laitance, and other foreign matter. Patch cracks and holes with an appropriate filler. Rough surfaces may be filled to provide a smooth surface.
Plaster: All new surfaces must be hard and cured according to the supplier’s recommendations—usually at least 30 days. Treat textured, soft, porous, or powdery plaster with a solution of 1 pint household vinegar to 1 gallon of water. Repeat until the surface is hard, rinse with water and allow to dry.
Wood, Pre-Primed Fiberboard, Hardboard, Plywood: Sand any exposed wood to a fresh smooth surface. Patch all holes and imperfections with a wood filler or putty and sand smooth. Remove all sanding dust.
Aluminum and Galvanized Metal: Wash with appropriate cleaner to remove any oil, grease, or other surface contamination using a water-based cleanerdegreaser. Remove all corrosion with sandpaper, steel wool, or other abrading method.
Caulking: Fill gaps between walls, ceilings, crown moldings, and other trim with latex or siliconized latex caulk after priming the surface.
Mildew: Remove before painting by washing with a solution of 1 part liquid bleach and 3 parts water. Apply the solution and scrub the mildewed area. Allow the solution to remain on the mildewed area for 10 minutes. Rinse thoroughly with water and allow surface to dry before painting. Wear protective eyewear, waterproof gloves, and protective clothing. Quickly wash off any of the mixture that comes in contact with your skin.
DO NOT ADD DETERGENTS OR AMMONIA TO THE BLEACH/WATER SOLUTION.
1040 MASONRY PRE-COAT: Concrete, Masonry.
1420 ONE PRIME: Wood (Exterior/Interior), Ferrous Metal, Non-Ferrous Metal.
Airless Spray: Pressure - 2000 psi, Tip - .015”-.019”, Reduction - Not necessary.
Conventional Spray: Air Pressure - 40 - 60 psi, Fluid Pressure - 20 psi, Tip - 704/FX,
Reduction: Up to 473 ml water / gallon.
Brush: Brush - Nylon / Polyester, Reduction - Not recommended.
Roller: Cover - 6 mm - 19 mm (1/4” - 3/4”) synthetic, Reduction - Not recommended.
Recoat: 8 hours
Dry - 1.5
TOTAL PIGMENT 20.5%
Acrylic Resin 25.3%, Additives 9.1%, Water 45.6%
TOTAL VEHICLE 79.5%
Weights & Measurements +/-3.0%
Solids by Volume: 37.0%
Solids by Weight: 47.1%
VOC: 42 g/l
Weight Per Gal: 10.3 lbs.
Viscosity: 100 - 104 KU